P, PR-Microbushing .3750″ Diameter

Pinpoint

This tip style uses a pinpoint gate design to allow the absolute minimum gate vestige possible. In the “P” configuration, the gate well area is machined directly into the mold cavity by the mold maker. In the “PR” configuration, a gate interface cap is threaded onto the end of the bushing, which allows for installation through a .6250″ diameter reamed hole in the mold cavity. Both configurations feature a field-replaceable tip, constructed with a very highly thermally conductive material.

P PR-Microbushing

Conan-Microbushing .3750″ Diameter

The Conan bushing was specifically designed to mold very small parts using glass-filled LCPs. It is used extensively in the injection molding of high precision electrical connectors. It will run at sub six second cycles with no drooling, stringing or freeze-offs. It is most often used by gating into a runner. The gate vestige height will be approximately 1.5 times the gate diameter.

Conan-Microbushing

General Purpose Microbushing .3750″ Diameter

The Conan bushing was specifically designed to mold very small parts using glass-filled LCPs. It is used extensively in the injection molding of high precision electrical connectors. It will run at sub six second cycles with no drooling, stringing or freeze-offs. It is most often used by gating into a runner. The gate vestige height will be approximately 1.5 times the gate diameter.

Conan-Microbushing